Bell & Gossett 179054LF In-Line Mounted Series 90-40S Centrifugal Pump 1.5Hp 115/230V 1-Phase 1750 RPM 2"

The Series 90 In-Line Mounted Centrifugal Pump is a close coupled, space saving, low maintenance pump capable of performing a wide range of fluid applications. The Back Pull- Out feature allows the pump to be serviced without disturbing system piping. The Series 90 pumps are available for pipe sizes from 1" to 2".

Applications:

Series90 Pumps may be used for hydronic heating and cooling, domestic hot water, cooling towers, machinery cooling, pressure boosting, industrial fluid transfer, refrigeration and heater exchanger circulation. Bell & Gossett recommends that bronze constructed pumps be used for pumping potable water. For other applications contact your local Bell & Gossett representative.

Operational Limits:

Bell & Gossett Series 90 Pumps are designed to pump liquids compatible with their iron or bronze body construction. Unless special provisions have been made by ITT Bell & Gossett, the operational limits for Series 90 Pumps are listed below.

Maximum Working Pressure: 175 psi
Mechanical Seal:

• BUNA – PH Limitations 7-9; Temperature Range –20 to +225°F
• EPT – PH Limitations 7-11; Temperature Range –20 to +250°F

Support & Location:

The Bell & Gossett Series 90 Pump should be installed where there will be sufficient room for future inspection, maintenance and service. It is highly recommended that service valves (shut-off) also be installed on each side of the pump to facilitate servicing or replacing without draining the system. Special precautions should be taken to avoid sound and vibration transmission. If the pump is to be located near a noise sensitive area, consult a sound specialist.