1-866-494-4610

Honeywell S87B1016 Single-rod Direct Spark Ignition Control with 11-Second Trial and Lockout Timing

Honeywell S87B1016 Single-rod Direct Spark Ignition Control with 11-Second Trial and Lockout Timing
Images for general purposes only. Actual may be different than depicted.
Honeywell S87B1016 Single-rod Direct Spark Ignition Control with 11-Second Trial and Lockout Timing

Honeywell S87B1016 Single-rod Direct Spark Ignition Control with 11-Second Trial and Lockout Timing

SKU: S87B1016
In Stock 8
Rating:
$240.69 /ea
Qty of 5 - $198.88 /ea
0
$0.00
0
$0.00
0

The Honeywell S87B1016 DSI Ignition Module provides electronic control of direct spark ignition systems for gas fire furnaces, boilers, and other heating appliances. The S87B series uses a single electrode to spark ignition and sense flame. The S87B can be used with any gas controller designed for direct spark ignition (DSI) applications rated at 2 amps or less. The 1016 model operates at 24 volts and has an 0.8-second flame failure response time. There is no pre-purge on this model and a single trial for ignition. If it fails, there is a shutdown and 11-second lockout, followed by an 11 second ignition trial time.  This model also includes an alarm terminal. The S87B1016 can be used with Natural or Liquid Propane gases. For installation and wiring diagram instructions see the Technical Data tab, however, it always recommended that installation and service be performed by a licensed technician.

Features:

  • Control ignition sequence and gas control operation.
  • Generate high voltage potential for main burner ignition.
  • Lockout after one trial for ignition if the main burner fails to ignite.
  • Reset from thermostat after a lockout.
  • Use modules (except S87C) with any combination gas control designed for direct spark applications and rated 2.0A or less
Voltage 25 VAC
Frequency 60 Hz
Current Rating 0.2A at 25 VAC
Valve Contacts 2.0A at 25 VAC
Alarm Contacts 0.5A at 25 VAC
Thermostat Heat Anticipator Setting 0.2A plus valve current draw
Flame Failure Reignition Time 0.8 sec maximum
Flame Current Signal Required 1.5uA

Following are the Attached files for this product:

Honeywell S87B1016 Direct Spark Ignition Control Technical Datasheet

Q & A: Ask the Questions, share answers

Do you have questions about this product?